Chesapeake Auto Repair

For drivers, S stands for safety.  And there are three other words that start with S that are all equally important: starting, stopping and steering. For your vehicle to be at its safest, all three functions must be in top shape. 

Steering is one of those things we take for granted.  After all, you turn the wheel and your vehicle changes direction. But sometimes you might notice your steering is a little off.  Maybe you've noticed you turn your wheel slightly and your vehicle doesn't turn. You may feel a little vibration in the wheel that increases when you go faster.  You may hear a little squeak from the wheels when you steer and you may notice your tires aren't wearing evenly.

These are signs that your tie rod ends may be failing. Tie rod ends help connect your vehicle's steering mechanism to the wheels.  They can wear out after you've hit one too many potholes or just from constant use.  They can cause sloppy steering and loose handling, and they should be replaced when they've reached the end of their life span.

If you notice any of these things happening on your vehicle, bring it in to us so a technician can check it out.  There are a couple of different types of steering, recirculating ball steering and the one most of the latest vehicles have, rack and pinion. When we replace your tie rod ends, we will remove and replace the old ones and adjust them to meet your vehicle manufacturer's specifications.

Tie rod ends should often be replaced in pairs, and your vehicle should be aligned afterwards.  Keep your steering working the way it's supposed to, and your vehicle will be sure to steer you right.

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

When you're driving and turn a corner, you probably aren't aware of all that's going on with your wheels.  The outside wheels have a longer distance to travel than the inside wheels, so there are gears that allow the wheels to go at different speeds when you turn. 

That set of gears is called a differential.  In front-wheel drive vehicles, it's by the transmission and called a transaxle.  Rear-wheel drive vehicles have the differential, naturally, on the rear axle. Many all-wheel and four-wheel drives add a center differential since power has to go to the front and rear wheels. (Some newer vehicles power wheels with electric motors, but that's a whole different story.)

Time and distance traveled eventually can take their toll on the differential, and you may notice some noises you hadn't heard when your vehicle was newer.  Sometimes you'll hear a whir that might change in pitch when you turn.  You may hear clicking sounds when you're moving.  Others describe rumbling sounds coming from underneath during a turn. Another symptom of possible differential problems may be vibrations or shakes the faster you go. 

All of these could be signs that you have problems with a differential. One common cause of differential problems is the gears aren't getting enough lubrication.

These can all have serious effects on your driving.  You may find it hard to turn, or your wheels may lock up. That could put you or drivers around you in a dangerous position. 

It's better to take care of differential problems before they get too serious.  Bring in your vehicle so we can have a technician check yours out.  They can see if there are any differential fluid leaks or failing gaskets.  In some cases, we may recommend your differential fluid be replaced.  And if there are any mechanical issues, some components may need to be replaced as well. 

When your differential is maintained, you'll be doing your vehicle a good turn.  

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

It's easy to get letters like PVC and PCV mixed up.  PVC is a plastic that's used in a lot of things, especially plumbing pipes.  And PCV is a valve that helps your engine burn off excess fumes rather than having them pollute our atmosphere. 

PCV stands for positive crankcase ventilation.  When your engine ignites gasoline in the cylinders, some of the gases produced make their way into the crankcase, where oil is held to lubricate the engine.  In earlier days, those gases would be vented out through a hose and go directly into the air.  It was a waste of gasoline (since about three-fourths of the gases were unburned fuel) and a nasty source of pollution.

So engineers devised a one-way valve that directed those gases back into the engine's air intake system to be burned again.  After a while, the PCV valve can get clogged up with gummy oil.  Not only does that reduce the recirculation of the gases, but it can also cause pressure in the crankcase to increase and possibly lead to an oil leak.

Signs your PCV valve has failed are oil leaks around the engine compartment or under your vehicle and poor engine performance. Your fuel economy will get worse. If you notice those signs, we can check your PCV valve. 

At the same time a technician inspects the PCV valve, they'll also check the vacuum hose that runs back to the air intake.  Plus, they'll make sure the vehicle doesn't have any other engine problems that might be contributing to your issues. 

Many technicians recommend replacing your PCV valve with each major tune-up, so you get ahead of any problems before they develop.  Now that you're an expert on PCV, it may be time to check out those PVC pipes in your bathroom!

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

Ever wonder how your vehicle’s transmission is connected to your wheels? After all, when you hit a pothole or some other uneven part of a road’s surface, there has to be something that can maintain the connection between the transmission and the wheel yet keep everything moving at the same speed. 

That very cool device is called a CV joint, a kind of driveshaft running to each wheel.  The CV stands for constant velocity because it keeps the drive wheels moving at a constant speed (velocity).  They’re used mostly on front-wheel drive vehicles but also in rear-wheel and all-wheel drive vehicles.

The joints move up and down and adjust to bumpy surfaces.  Plus, they are covered in a rubber boot which protects them from road debris and also holds lubrication in.  There’s a CV joint and boot on the transmission side and one on the wheel side.  Unfortunately, the spot that usually fails first is that rubber protective cover (the boot).  After a lot of wear, tear, bumps, road hazards, heat, and you name it, the rubber rips and the lubrication leaks out.  At that point, it must be replaced. 

Here are signs to tell if your CV joint is bad.

• Your vehicle is pulling to one side as a wheel loses power or you feel a vibration while driving.
• You see grease on the inside or edge of your tires.  
• Your front tires won’t point in the same direction.
• You hear grinding or clicking when you turn.

Sometimes if a broken boot early is caught early, a technician can pack in new grease and replace just the boot.  But if the lubrication has leaked out and the joint is already wearing badly, the CV and boot both have to be replaced.  Give your vehicle the boot (as in a new boot) and CV joint, and you’ll be back on the road to your next destination.

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com