Chesapeake Auto Repair

Who thinks about their fuel gauge?  You probably don't… until it doesn't work any more.  Then you have to guess how much fuel is in your tank, and that's no way to live life on the road. 

Fuel gauges, like every other part in your vehicle, can fail.  And when yours stops working, you will probably want to head over to your service facility soon, because no one relishes running out of fuel.

The fuel gauge system is much more than just the gauge you can see on your instrument panel. Most systems have a float inside the fuel tank that goes up and down depending on the fuel level.  It's called the fuel sending unit, and it sends an electrical signal to the gauge (on the dash) telling it to display how much fuel is left in the tank. 

So, what could go wrong?  Well, a few things.  For one thing, corrosion from bad fuel can cause it to stick and it won't move up and down any more.  So you could fill up your tank and the gauge would still read Empty.  If a sending unit needs to be replaced, often the parts can be costly. The good news is that fuel sending units rarely fail and most drivers will never have one go bad.

Other things that can go wrong? An electrical problem could cause a fuse to blow and you won't get a reading at all.  A technician can figure out where that electrical problem is and how to repair it.  Finally, it's possible for the gauge itself (on the instrument panel) to fail.

One thing to keep in mind is if your fuel gauge isn't working, you might be tempted to carry around an extra container of fuel.  That's ok if it's outside the cabin, such as in the bed of a pickup.  But if you carry it inside the cabin or trunk, fuel fumes can be very dangerous for your health, even fatal.

A working fuel gauge gives you peace of mind… so you'll never have that "empty" feeling.

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

When the leaves fall, you might take a sightseeing trip to see them at peak color.  Or you may simply live in a spot where there are a lot of trees.  When those leaves get wet, you'd be surprised to learn just how slippery they can be. 

We all know ice is slippery to drive on.  What causes tires to slip on ice is a thin layer of water that comes between the road and your tires.  Wet leaves can have the same effect.  The surfaces of leaves are super slick when they're dry, even worse when you add a little moisture.  There's one other thing about leaves.  They are smaller than each tire's footprint, so your tread grips the pavement with uneven traction.

One study showed that your stopping distance can more than double on a surface covered with wet leaves when compared to that same road when it's dry.  Double! That can spell trouble.  So if you find yourself heading into an area with wet leaves on the road, slow down before you get into a jam.  If you do start skidding, use the same driving techniques as you would on ice.  Let off the accelerator, resist jamming on the brakes and steer into the skid.  Again, speed can get you into trouble fast on a slippery surface.

One thing that can help is having tires that are appropriate for the way you drive and the places you travel.  Your service advisor can offer suggestions for tires that are right for you.  Have a technician examine your tread depth and the condition of your tires' rubber.  Sun can break down rubber over time, and age can cause tires to fail, even if their tread seems to be deep enough. 

Your tire is the point of traction between your vehicle and the road.  Uncontrolled skids spell trouble and danger.  Slow down when you see wet leaves on the road.  They can make traction disappear before you know it.

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of. 

Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening.

Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up. 

It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technician to get to.  That means labor costs will vary depending on the design of your vehicle. 

Occasionally, a faulty resistor can cause the blower motor not to work at all or only partially come on.  But other things can cause that as well, such as a faulty fan switch or vent control. 

This is where a technician's training comes in.  Special equipment can track down precisely where the issue is so you can be assured the correct part is being replaced.

It's just not pleasant when the blower motor isn't following orders.  Have your service facility check it out so you can be the blower's boss, like it should be. 

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

When's the last time you thought about spark plugs? You probably don't remember.  That's because spark plugs usually last a long time and don't need much attention.  But they don't last forever, and when they start going bad, they'll send you a few clues.

• Vehicle is hard to start. 
• Fuel economy is going down
• Acceleration isn't what it used to be
• Engine runs roughly
• Check Engine light is on

There are many things that can cause those symptoms, so it's wise to head on over to your vehicle repair facility to have them look over your vehicle.  But the problem could be your spark plugs. They do wear out, not producing a strong enough spark to ignite your fuel the way they're designed to.  A closely related problem is failing spark plug wires, and a technician will test for both possibilities… and more. 

Your vehicle's manufacturer recommends changing wires and/or plugs at certain intervals.  Spark plugs are made out of different materials and some last far longer than others.  Ask your service advisor to let you know when yours should be changed.  Badly misfiring plugs can cause expensive damage to a vehicle's catalytic converter, so it's best to take care of them before that happens.  Replacing your spark plugs and/or wires is money well spent to have your vehicle running smoothly, dependably and efficiently.  

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com