Chesapeake Auto Repair

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles.

That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners. 

Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usually last a long time without any problem.  But sometimes they fail, either from being hit by debris or age causing the rubber or plastic to deteriorate.  That can allow the grease to leak out of the joint and the moisture to get in.  And that's where the trouble is.

So it's important to have a vehicle's CV boots checked periodically, especially when they begin to have more than 100,000 miles/160,000 kilometers on them.  A technician inspects them for tears or cracks.  Sometimes if the problems are found early enough, the boots can be replaced and the joints can be re-packed with grease. 

But sometimes the CV joint can wear out even though the boot is intact.  When the CV joint fails, you might hear a grinding, humming or clicking noise and feel vibration.

Some of these can be difficult to access for service, so many service advisors will recommend replacing the joints and boots at the same time.  Just remember, new CV boots won't make a fashion statement, but they will keep your vehicle going down the road for years to come.

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

It's a light many drivers fear they'll see turn on at the most inopportune time.  It's the one on the dash that says "Check Engine," "Service Engine Soon," or it may be simply an engine-shaped light. Your first instinct may be to pull off to the side of the road and turn off the engine.

The truth is that Check Engine light can be pointing to problems as simple as a loose gas cap. But it could be as serious as a severely misfiring engine.  Don't ignore it because it's there to help you avoid an expensive repair it is designed to alert you to, to tell you something's not quite right.

Your vehicle has a connected system of computers and sensors constantly checking to see that all systems are working the way they should. If something isn't, the system will turn on the Check Engine light.

If it's flashing, that could be serious. Look at some of the other warning lights or gauges such as heat or oil pressure. They could be telling you your vehicle's problem should be checked right away. In that case, if you can, safely pull off the road and shut the vehicle down. If your vehicle loses power and the Check Engine light is on, try not to push the demands you are making on the engine, such as towing or accelerating hard.

Simply put, a flashing Check Engine light should be checked out by a professional as soon as possible.

If the Check Engine light is on steadily, manufacturers say it means there's a problem, but it probably doesn't require immediate service.  The system is designed to remember the problem it found and store it (as a code) so it can be retrieved later.

When you do bring your vehicle in to have us see what's behind the Check Engine light coming on, we’ll hook your vehicle up to a diagnostics tool that can reveal the clues the engine's computers have stored.  It takes a trained technician to understand those clues, like a doctor who can interpret a patient's symptoms and come up with the correct diagnosis. Some newer vehicles can even be checked remotely.

Once we figure out the problem and repair it, you'll be back on the road again. It's nice to know the Check Engine light is your sentry, standing by to alert you the next time you begin to "see the light."

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

You know your body temperature is supposed to be 98.6 degrees F, 37 degrees C.  Your vehicle has a normal temperature, too, and if you pay attention to it, that can save you some big headaches down the road.

Many vehicles have a temperature gauge on the dash that takes the temperature of the engine's coolant.  Some have a thermometer symbol, some read C-H (cold to hot). Many will have a red zone that shows when water temperature is getting into the danger zone.  Others are digital and have a red warning light that signals overheating.  And some vehicles have a light that goes on when the engine temperature is out of the normal range.

If your vehicle has a gauge, pay attention to it.  If you need help locating it, ask one of our West Service Center experts to give you a quick explanation.  Chances are when the vehicle has been running for 15 minutes or more, the temperature gauge will settle into its own "normal" zone, often just below the midway point.  If you have a digital readout, remember what that "normal" temperature is.  Here's why.

At any point when you're driving, the temperature gauge is the quickest way to get a sense that the engine is running the way it should, a quick health checkup, as it were. Say you're on a 3-hour trip, glance at that gauge every hour or so.  It should always be in the same spot.  If it starts to move one way or the other, you may be able to catch a problem before it gets serious.

Pay special attention to it moving into the hot zone.  The needle on the gauge is the easiest and least distracting way to see an engine heating up, but on a digital gauge, start paying attention if the temperature reaches 240ºF/115ºC or more.

Remember, though, that just because the gauge reads "hot" doesn't mean your engine is on the verge of burning up.  It could be a bad sensor and the engine will be at a normal temperature.  But it also could be a failing water pump, coolant leak or thermostat.  By pulling off the road and observing your engine, it will give you a pretty good idea if it's running hot or not.

If the gauge is too "cold," it could be a broken gauge or thermostat sticking open.  Usually being in the cold range isn't as worrisome, but you should have it checked out since other systems may be affected.

Heat is one of a vehicle's worst enemies, especially when it comes from within.  Know your vehicle's normal temperature and keep an eye on it.

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com

Mirror, mirror on the door, why is my vision there so poor? Well, you could have a broken outside rearview mirror that's disabled your blind spot vision there and endangering your ability to see some of the traffic around you. 

Outside rearview (or door) mirrors are important safety devices that are thoughtfully designed to help drivers see.  And there are a variety of ways those door mirrors can develop problems.

One is when the glass is broken in them.  Sometimes it's caused by an accident or vandalism.  But without your ability to see in that mirror, you could be driving blind, unable to see drivers approaching from the rear in adjacent lanes.  Sometimes it's as simple as having the glass replaced.  You'll greatly enhance your safety if you do.

Then there's the door mirror that you can't adjust.  First, let's look at a common scenario in later models, the power mirror.  They're great when they're working, awful when they're not.  Sometimes the motor fails, the switch goes bad or the wiring fails to deliver power.

Or how about the manually-adjusted door mirror that has either frozen up or just flops around? In this case, the mechanism has corroded, jammed up or a part has broken.  In both power- and manually-adjusted door mirrors, it sometimes can be hard to keep them in the right position.  Plus, every time there's a driver change, it may be hard to adjust those broken mechanisms by hand.

Finally, heated door mirrors can be extraordinarily useful in eliminating fogging or icing up in certain weather conditions.  But those heating elements can fail, switches can break or wiring can go bad.  Suddenly your fogged over, frozen mirrors aren't doing you any good at all. 

Good drivers use those outside rearview mirrors all the time.  They should be working the way designers intended, to provide the driver with vital traffic position information.  That's the kind of safety device you should get fixed or replaced sooner rather than later.  It's well worth it if you prevent even one little accident. 

West Service Center
904 Cavalier Blvd
Chesapeake, Virginia 23323
757-487-4420
http://westservicecenter.com